Mobile Bridge 1/10 Scale RC
by InEarthsOrbit, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
This is a 60cm mobile bridge for use with 1/10 scale crawlers (and tanks?)
This symetrical piece is made to fit together with itself once assembled and will fold in half for storage but be strong enough for use with <10kg scalers and RC trucks.
Simple print four "pivots" + "ramps" and two "pins"
The main part is 20.5cm long so it should fit most printers.
Epoxy the "ramp" into the swivel key permanently.
I was hoping to surprise a fellow RCer with the design for his RC4WD Beast 2. The ridges provide more than enough grip for my stock SCX10 to climb them at a good 60degree angle.
Bottom of bridge too slippery?
These bridges are meant to be spray-painted with a flat olive or grey primer and silicon/rubber-dipped at the tips. if you use the bridges "as-is" I recommend using the hook material from adhesive velcro.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingTools and Utilities
Repair, slice, or enhance this Thing
Mobile Bridge 1/10 Scale RC by InEarthsOrbit is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving InEarthsOrbit a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure InEarthsOrbit would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).