Robo 3D R1 Storage Hanger

by roofus4 Sep 26, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

I just printed this part out a second time after upgrading my Robo with a Volcano. Printed out in about 9 hours and I had to add 3% to the width to get it to clamp around my Robo. I used PLA with 50% infill. I had the length running along the y-axis and had to offset the bed a little bit in S3D to get it to fit.

Witch file should I download

The difference between the two files is the side walls. On the one with 6 in the title, the tops of the sides are parallel with the bottom, where as the one with 7 in the title, the tops of the sides angle up to meet the back at a higher point. Just a style difference. I thought I'd put both in here and let folks decide which one they want.

Comments deleted.