Wanhao DI3 filament guide Ver. 6 (upgraded)

by WINTERKILL Oct 4, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

On v5 I spent hours making it and it printed perfectly (with supports), but all it does it click, slap, etc. and that's when it's not sliding back and forth because it's extremely loose. I may try v6 but it really seems that at least the filter free version, that the top hole is just a little too close to the frame, causing the filament on the bottom guide ring to constantly "slap" and rub the side on the frame, actually to the point where that friction is scratching the filament and I worry about it affecting the tolerances.

Again I may try to print v6 to see if it stays in one place and perhaps that also changes the angle ever so slightly enough to alleviate the other issues.

Thanks for the design though, of all the guides I really like the way this one looks!

Which is the best way to print this, the one with filter.

Added a v6 with filament filter add on. As Requested by Quantumlight.