This is a remix of http://www.thingiverse.com/thing:882810 . Thanks to djui for providing the Antimony source file so I could modify it.

38mm version

The original version was made for the 42mm version of the Apple Watch, however I always needed to lift my Apple Watch a bit when in the stand so that it will be charged. Therefore I've modified the original design so that the 38mm version fits well.

larger cable channels

I made the cable channels a bit larger to also fit my charging cable. It could be even a bit larger than in my modified design.

charger removal slot

I was always afraid I could not remove the charger from the dock once it's plugged in. To overcome this anxiety I added a slot from the bottom that is invisible and can be used to remove the charger cable.

Notes:

If you look at my pictures you see three designs:

1. the one by djui
2. my first modification with a charger removal slot
3. the final version optimized for my 38mm Apple Watch and a larger removal slot

Tip for printing: The first version by djui I printed with more infill, so it's a bit heavier. My later versions are too lightweight and if I'd reprint them I'd use more infill again.

Since Antimony creates huge STL files which I couldn't print I then post processed the 100MB STL file using MeshLab so that it could be printed and now its 3.5MB in size.

I also added the Antimony source files again to keep the spirit of sharing.

Update

Now a 42mm version of the final STL file is also available. I simplified the STL quite a bit, so you can leave a comment if a version with more faces is needed, but you can also use Antimony to create a highly detailed version. I also forgot to mention that the STL files went through netfabb in order to remove any model errors, if any.

Have fun!

Doesn't Matter

Doesn't Matter

If you want higher weight, use more infill.