A simple parametrized openscad file to create organizer boxes for common tool chest drawers. Features:
1) Rounded corners
2) A Little inclined flap at the top to put a sticker w/ contents description
3) Optional middle separator.
The default setting is to create an 8x4 grid of boxes in a 32 inch Craftsman tool chest.
This prints in PLA as well as ABS. Lifting of the corners is a bit a problem so make sure you tie it down with abs slurry or dilluted elmer glue in the corners. But don't apply too much in the center, because its a rather big object with plenty of contact surface it could become rather difficult to get it off the plate.