Loading
kartcrg

MakerGear M2 Geetech LCD Case & Mount

by kartcrg Oct 13, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

The LCD panel I received from Makergear has protruding components that prevent it from fitting on the back piece. I was going to modify the design when I found this one which fits perfectly with the existing front panel: https://www.thingiverse.com/thing:1162868

MakerGear M2 LCD housing for geetech LCD
by glegee

Fits nicely, a better looking part than what I had before.

I'm going to beef up the back support with added/thicker ribs -- it flexes a bit more than I would like when I push the button.

I also probably will use the upper 2 screw holes on the side of my frame so I can mount my electronics on the side just below it. Just means an additional hole on the bracket to allow a choice (no big deal)

Thanks, otherwise VERY nice!

Thanks for the feedback mate. Just note, I mounted it on the two lower holes because that was as far as the wires from the rambo would reach. There is still room for the power supply under it (but I assume you're referring to other electronics). Glad you're improving the design!

Any chance you could share the solid models, that would make it much easier to modify. Thanks in advance...

Uploaded a step file.

Brilliant, thanks. I've added ribs and a few other details, will upload (somehow) once I prove it out. Love this forum!

Nice! Looking forward to checking it out!

I did a remix, thanks again!

What LCD display is that?

MakerGear M2 Geetech LCD