This is a supportless printable birdhouse that will snap together.
This was made to the likings of a "Wren" Type bird.
You might want to scale the print to fit your print bed. pieces are a bit bigger than five inches across.
Print each piece oriented flat, with the most surface area of each part on the build platform.
There is eight, unless you don't need the hook.
To assemble: Start with the top piece with the three rectangle holes near the middle.
-Slide each of the side panels with the Wren shape cutout onto the tabs of the top panel.
-Slide the front panel with the crescent and round holes onto the mating four tabs of each Side panel.
-Do the same with the blank back panel, slide it onto the mating four tabs on the rear of the birdhouse.
-Fit the Bottom panel into each of the six tabs on the bottom of the four walls
-Insert the bottom of the hook down through the top panels big middle rectangle and turn align the two tabs of the hook with the two smaller rectangles on the top panel.
(See things pictures above for help.)
Write me a comment if i need to refine this somehow.