This is a "robotic moth-bee" loosely based on a sketch by my wife.
Story and more pictures here: http://wp.me/p2hTaI-26
One-piece version (beething) requires raft/support for overhanging wings.
Two-piece version (mothbee_body & mothbee_wings) should be able to print raftless, then glued together. I've not printed this version so YMMV.
NOTE: the original size is rather small but a good size for a pendent, while 2x is a little too large for a broach or pendent. 1.5x may be good for any of the above.
Finish as desired. Plastic glue on a pin back if you want to make into a broach, or hanging O-ring for a pendent.