This is a completely new part made for hANDi Hand Orthose
The purpose is to make it easy to collect the lines from the fingers to the spring without having to make those tiny knots.
I did Knut at first and that thing works just fine but you have to put tension on all 4 finger lines at once wile tighten it.
On "Knut 2" you can tighten each line separately... and the spring is a separate screw to..
Of course "Knut 2" can be used for much more than on "hANDi"
There are 1 connection in one end and 4 connections in the other end.. the sky is the limit ;)
There are two files.
One is made after correct measurements of the nuts.. That however were to tigt for me after printing so the other file is scaled up to 1.2 and that worked just fine...
I printed it with the 4 nut holes facing up... to avoid having to get a lot of support material in there that is hard to get out.
i used layer height 0,2mm
I had to trill up the 1mm holes that the line is going trough.. I have some problems with my prints and inner dimensions :P
Tell me if you encounter that problem to, in that case I have to make the holes bigger.
You need 5 pieces M3 screws and nuts for this model :)