So, this model originally had a few problems, in my opinion. The embedded radar didn't make a lot of sense and it made it harder to cleanup after printing. The gun breeches were separate, to be glued afterwards, so I thought, why not print them as one part? That helps avoid potential misalignments and produces a stronger part overall.
So I fixed those problems and remixed it.
What to print:
4x gun barrel
1x gun breech left
1x gun breech right
4x gun magazine
2x gun swivel
1x radar base
1x radar top
1x turret panel reviewed
1x turret panel 2
1x turret reviewed
1x turret swivel
1x turret vision
0.1 for most of parts, 0.05 for radar dome
Only the breech might need support, due to an overhanging part in the top end. No need to print mirrored parts.
Cleaning and priming
These steps are made with the model UNASSEMBLED
Step 1: Clean model with x-acto knife
Step 2: Sand model with coarse sandpaper, can be wet sanded.
Step 3 (optional): Apply filler to whole model and then sand again, with progressively finer sandpapers.
Step 4: Apply primer paint, preferably grey to better see imperfections. Apply filler and sand again if needed.
Step 5: Assemble the model and bask in it's glory
Step 6 (optional): Paint with acrylics.
Step 7: ?????
Step 8: Profit
Modelled in Rhino after the original components