Mini FPV Tricopter
This thing is a work in progress, so may be updated over time as I try out different motor/esc combinations.
Designed using autodesk fusion 360
To complete the tricopter, you will need either 2204 or 1806 motors X3
5 or 6in props
Savox SH-0257MG servo
6mm diameter carbon fibre tube for arms cut to 150mm length X3
Power distribution board
5v UBEC if using DYS ESCs
I use DYS20A BLHeli ESC's X3
Naze32 / Mini KK2 or mini APM compatible FC
I use a Naze32, however if you use any other FC other than the naze, don't print out the cover, as it only fits the Naze32 boards
If using the 1806 motors, please print the spacers for the front arms
Designed for the mobius action cam and 1000mAh 3s batteries.
Added, landing gear adapter, fits universal landing legs
I used supports on the the motor mounts.
On the top plate, the counterbores (wide screw holes) need to be on the the bottom layer when printing otherwise you may not be able to bolt the top half to the bottom cleanly.