Prusa i3 X-Carriage w/ servo mount (for auto level), end stop and cable tie loops.
Three versions included.. One with Servo Mount and front to back cable tie hoops, one with cable tie hoops front to back, the other side to side.
31mm servo arm file is also attached here. That was the shortest one using the SCAD file I already had, that left enough room for the servo plastic that comes with the SG90 servo.
Up to you what you use. SCAD files included, highly recommend to make sure your cable ties fit the holes, make them larger if necessary. You will need the original STL from the item I remixed this in order to make modifications with OpenSCAD.
Notes now that I have installed this
1) The stock Folger Tech extruder setup bolted right on, no problem.
2) The 31mm servo arm is extremely short. I may make a longer one. Not sure yet.
3) The nub for pushing the end stop does not extend toward the front of the printer enough. I will probably add a mounting hole there, so that a little "nub" can be bolted on and extend far enough out to hit the end stop I want to use.
Holes are spaced 30mm apart, I plan on using this on a Folger Tech Prusa i3 2020.
Meant to use this X end stop: http://www.thingiverse.com/thing:765805
Remixed from " Migbot I3 X-carriage with endstop" by Dre363
which was remixed from "i3 X-Carriage for GT2 & T2.5 with added 30mm holes" by mokash770