i created a nice looking adjustable leg for my 2020 printer. Someone asked for the same leg to fit their Kossel. Well, here it is.
The foot uses an M6 x 20-30mm hex bolt and the leg has space for an M6 hex nut. You may need to use a soldering iron or a little glue to keep the nut and bolt from falling out.
It uses M3 screws and t-nuts to attach to the 1515 rail. There is also a hole to screw into the end of the 1515 vertical upright.
There is also a version for the 2020 kossel. It uses the same foot and M4 hardware.
You can add a non-skid pad to the bottom of the foot to keep your printer from sliding around.
Since I don't have a Kossel yet, let me know if there are any adjustments I need to make.