Designed for DJI Phantom V1 and V2: XL-RCP 22.0 Wide landing gear kit. This is new improve landing gear to replace the original stock landing gear on DJI PHANTOM V1 and V2 series that was too narrow and short causing multiple problem such as tilt over and crash during uneven landing and not enough ground clearance to mount camera between the landing gear. So i decided to design and 3d print a new set of landing gear to solve the mentioned problem for my Phantom drone as described the above title. Not only its has wider stance and tall but also being stick rod type design allow it to land any where 'all terrain' poking any uneven ground without being tilt by several ground obstacles especially on tall grass where conventional heli type low horizontal landing skid design fail previously.
For more details and instruction check it at this url:
++ Do take note i'm using Z-modeler to build this 3D parts so would look "cracky" on some 3d viewer but no problem during 3D printing.