Thingiverse will be undergoing scheduled maintenance and will be unavailable from December 14 @11pm EST to December 15 @1am EST


Voronoi Turkey

by miked63017 Nov 25, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

As slimshizn pointed out, the bottom of this print won't lay out 100% flat ,and in my case, only gives me two small points of bed adhesion at about (9,15)mm and (-38,36)mm from the center of my build plate in my slicer (scaled up to 500% in Simplify3D) Even turning rafts on doesn't give me enough grip to feel comfortable with. I'd chance it if I didn't want to print with GITD filament as it might come out fine with standard filament, but I find good bed adhesion on the first layer to be absolutely necessary with GITD filament and need this done by the morning for the holiday and so can't chance it. I would love to see it fixed though, it's a great model and definitely worth refining.

Do you have the original turkey file? I have been looking everywhere for it. The number was 567544 and I looked for it now, and it is gone...

how much infill did you use on this?

Was excited for this till I saw that it won't lay flat 100%. The 2nd layer lifts off the print plate and would make a mess. Hope to see a fix as I'm not taking the time to bring this into meshmixer.

I am experiencing this problem as well. I am using PrusaSlicer at 0.15mm layer height with a 0.4mm nozzle. I as well hope to see a fix soon.

This was made in mesh mixer, and I have printed it dozens of times with no issue. Not sure what slicer your using, but I use slic3r as a secondary test with no problem. 2 slicers no complaints from either, not sure where the issue is at.

92 MB stl file?...... would you be able to post a smaller one? I have slow internet.

what software do you use to make that pattern on solid figures?

Meshmixer is what I used, but I think there is a few different softwares that do it. If you Google how to voronoi there is an instructable that walks you through it with meshmixer.