Replacement part.Orange elevator rail for the playset from "Masters of the Universe - Castle Grayskull" 1980's.
Printed, tested and confirmed. I left out the hole in the rail for the string. I usually just drill my prints afterwards. Just superglue the rails together. Before you glue the pegs to the rails, install it in the castle so everything lines up. then put some superglue on the pegs and snap in the rail. Also the pegs are gonna need some light sanding just to make a supertight fit.
The original design is flawed, putting too much stress in the rail when pulling the string which I assume is the reason mine broke. So I would advise to either hold a finger above the rail which you let the string slide over or a more permanent solution: Secure a hook in the castle roof or drill a hole in the roof. Haven't decided what I'm gonna do.