Loading
fozzy13

Geometry Connectors - Icosahedron, Tetrahedron, Cube

by fozzy13 Nov 28, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

I tried the cube connector and it's opening at 495mm in Cura. The tetra is opening under 1mm in size. Can you tell me what the correct size should be?

Upon looking at my modeling files again, the tetrahedron connectors specifically were modeled using inches, where each hole should be 0.252" in diameter. By scaling the model up by 25.4, you should be able to convert from millimeters to inches in Cura. The cube connector was modeled using the same settings, so you may need to scale it by the opposite, 0.00394.
I hope this helps!