Loading
Coucoudexav02

Case for Touchscreen 7" - Raspberry Pi 2B - Cam

by Coucoudexav02 Dec 5, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

So I printed it all out and everything is fitting nice but I read that I shouldn't power the touchscreen thru the pi USB because of the fuse so they want you to power the pi off the display board. On the cover the usb on the display controller is covered. How are you handling power?

Hello
why use usb power touchscreen external ?
rather use connector cable internal 4 pin (red black yellow green . view picture 1)

bye

note that this should be printed with 3 or more shells so that you have some margin to drill out the screw holes if needed. would be nice if the screw holes were a little bigger for the back cover. i don't normally stock such small hardware.

what size screw should i use to attach to the lcd? should be 3mm, but i'm unsure of length. hole pattern appears to be slightly too large. usb input jack could be a little larger. some more clearance on the side facing the LCD is needed. other than that, awesome!

heyy very nice..
I need to same design thanks for share