Raspberry PI Zero Case V1.1
by Nick_Kay, published
Liked ByView All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
Note: this is for v1.1 of the pi zero and does not have a hole for the camera ribbon on later versions
This is v.1.01 of the PIZero case. No screws needed, relies on a push fit. Gap in the lid of the case to allow access to GPIO pins, you dont even need to disconnect any wires to add or remove the PIZero from the case.
Print time: 2-4 hours
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingTools and Utilities
Repair, slice, or enhance this Thing
Raspberry PI Zero Case V1.1 by Nick_Kay is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving Nick_Kay a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Nick_Kay would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).