Doctor Who is headed back to Gallifrey this Saturday, so I decided there should be some Time Lord minifigs ready to meet him. All that was needed was a super-high tri-winged collar!
This is designed after the classic Time Lord collars/helmets that appear in the Doctor Who TV show. The design will print flat without the need for supports, there are supports built right in that you snap away once the print is done.
I even put the Seal of Rassilon on the shoulders. Enjoy!
Oh, and here's a little blog post about designing this. Stop by and give it a read, and subscribe if you like it! http://windthefrogblog.com/time-lords-use-extra-starch/
Snap away the three thin walls printed in the base of the collar. If you look at the snapshot of the 3D model in the gallery you'll see the three walls, they're colored red. It may take a little force to break them out, I use needle nose pliers to make the job easy.