This is an after market small (53mm) can holder for a Peugeot 307 that mounts to the fan ducts next to the door.
I quickly designed this holder as I have found the holders the Peugeot 307 I have are of less than optimal usefulness (many expletives used when my can of beverage spills).
This Can holder is design to fit a 53mm Can (has a 60mm hole) and mounts in a Peugeot 307 fan ducts next to the door. It may fit other models of Peugeot (no others have been tried). It's designed so the Can will not slip though the holder even if forced at an angle.
It can be removed but it may require the use of tools to do so. The vertical blades in the vent have limited movement with this holder fitted.
Note: Not guaranteed to fit any known or unknown car. All I know is that it fits my Peugeot 307.
Note: Use at your on risk!! (meaning that I assume no responsibility for any events or problems caused by it detaching while driving or otherwise reducing your ability to driver your car safely).
Note: It's not designed to be removed easily and may cause damage to your car while trying remove it.
There are 4 parts to make and assemble, I glued the parts with Acetone. All the parts key together to help align them.
It was printed on a MakerBot Replicator with the following setup:
Object infill = 20%
Layer Thickness = 0.2mm
Number of shells = 2
The "Vent_Clip.stl" part must be printed with support because it has over hangs. The other parts can be printed without support and all together.