Loading
carrtoonist

Apple Pencil Case

by carrtoonist Jan 5, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Hello

At the photos it looks smaller anyway I like it. But why I got this lines ? I used MakerBot replicator 5th gen and infill 30%.

Using a Dreamer like your code shows. Though haven't invested in Simplify3D. Challenge getting the piece to no mush when printing first few layers. Not too hot at 220 and 110. Your temp shows 230 105. I've had that as well and above. Don't know if the .15 or .2mm layer heights are causing it. Also use moderate to medium to 100% infill. To no avail.

Any tips could help. I haven't tried with a raft, as the FlashPrint software makes it next to impossible to remove. I am getting PVA shipped, to use that to dissolve.

I wish I knew enough about 3D printing to offer some solid advice. I will say that all my issues with the dreamer went away when I started using Simplify3D. Have you tried using the gcode I provided? I should mention that the gcodes are set up for ABS filament.