Just small buildings I needed for a diorama, inspired by a desert house I found here.
If you would like to have accessories, such as furniture for the buildings, or things on the Roof, please let me know, I will then make a set of those. So far I only have an A/C and the gas tank, but what else would you like to see?
Let me know!
If you print this, please share a photo!
Scale to scale:
1/100 print at 1,00
1/96 print at 1,04
1/84 print at 1,19
1/76 print at 1,32
1/72 print at 1,39
1/68 print at 1,47
1/54 print at 1,85
1/48 print at 2,08
1/32 print at 3,13
1/24 print at 4,17
1/18 print at 5,56 (realy?)
Prints without supports @ 190-200°C with PLA (see photo). Both a 0,3mm and 0,4mm nozzles are fine for the origial size. If you scale it down, use a smaller nozzle for the wall details.
I drew the footprint sketch, extruded this.
Then I added the roof beams, then the roof. Both are just oblong sketches, extruded.
The I cut the windows and the doors.
I added the roof walls later, also the stairs. They are just a sketch on that wall, extruded.
Details were then just extrusion-cut into the walls.
It took about 90min to do.