A small vise for the generic 4030 CNC router, it can hold stock up to 40mm wide.
It includes a clamp that can be screwed on top of the vise to hold down the stop more firmly.
It can use two or three of the T-Slot nut traps, if you use three you'll need two more M4x15mm screws and nuts.
It needs the following hardware to complete:
1x- M5x50 or 60mm bolt.
1x- M5 nut
4x- M4 nuts
4x- M4 washers
2x- M4x40 screw
4x- M4x15 screw
2x- M3x6 countersunk head screws (for the jaw guide bottom)
You will have to remove the print pads from the base after printing, also the holes for the clamp need to be tapped for an M4 thread, and the holes on the jaw bottom need to be tapped for a M3 thread.