A revised version of chewbone's Flashforge Creator Pro adjustable Glass Bed Bracket.
Changes to corner piece:
- This now has the screw slot the entire length of the corner so you can remove and swap these in without having to remove the pin completely.
- The corner piece is taller, with 9.5mm clearance for the bed + blue sheet if you still have it on.
- There is a lip that sits out 3.2mm over the bed to allow for glass plates up to 6mm smaller than the bed.
Added a blank corner piece with no lip to be screwed directly in place - aimed at back corners where adjustment may not be wanted.
Print these in ABS as they will be subjected to high temperatures when in contact with the bed.
It was possible to print these directly on the bed with no raft and I printed at 50mm/s maximum to ensure the corners were as accurate as possible.