My 1st experience with designing a piece from nothing. I needed some drawers for my electronic parts so I made this.
I will make a module for the spools of wires a bit later
I tested this with Wood filament, PTEG, PLA
ABS will warp too much for the shelf part, I can probably make more holes to relief the stress.
but I don't need it myself
-New drawer with compatible hook for DinRail (http://www.thingiverse.com/thing:1581801)
-Label holder on separators and increased gap of separator by 0.1mm
- Is for the printers that are moving and shaking it too much, the middle supports can collapse.
-Will save about 100g of material over 3.1 at 100% infill.
-35% it is about 332g of PLA material instead of 376 @ 35% infill.
-I Print these at 10% total 310g
-Added some tabs to allow the back to stick better to the base
- Thicker, easier to remove and reuse separators
-Scaling by 1000 may be needed, my units are mm in blender.
-New design for the drawers, pictures will be updated, this handles can fall off while printing.
Better to print the shelf with the back on the build plate.
If you have a bed that moves be careful with the speed as the mid support mid fall off and destroy your print.
The drawers can be printed without issue. The bottom part of the round edge might not stick so well, but it works on my FFCP.
If there's a demand I can the drawer make 2, 3 wide or 2/3 high.
I plan on adding drawers with spools and a spool rack on top of it.