Finalized Parts! Feel free to download, as these won't be changing anymore.
CowTech Ciclop, designed from the BQ Ciclop, but redesigned to use half the print time, 2/3 of the filament, and a tiny print bed area of only 115mm x 110mm x 65mm (4.5 x 4.3 x 2.6in) so the parts can be printed on nearly any printer. Funded on Kickstarter, raising $183,800 from 1400 backers. Kits now available for pre-order at www.cowtechengineering.com
You will need two each of the laser core, laser holder, and pattern holder.
PLA or ABS are both fine.
Laser Cut Parts. All sizes in inches.
1x Top T .220
1x Bottom T .220
1x Faceplate .220
1x Turntable .220/.236
1x Frosted .062/.125 (if you don't have frosted acrylic, lightly raster the surface)
1x Pattern .062
3x Wire Holder .220
2x Laser Arm .220
Some of the previews look funky, but they donwload accurately.
Camera Base : Support everywhere, no platform adhesion needed
Motor base : Support everywhere, no platform adhesion needed
Camera Holder: No support, no platform adhesion.
Backplate : Support everywhere, no platform adhesion needed (print standing up with flat side down).
Laser Holder : Support everywhere, no platform adhesion needed
Bearing Holder : No Support, no platform adhesion
Laser Holder Core : No Support, brim or raft suggested
Gear : No Support needed, brim or raft suggested
Note: Orientations do not necessarily match suggested printing orientation.