I Made 5 angular versions of the 37mm Connector. 7, 10, 12, 17, 20° to get that spidey look and less prop in your Field of View!
I wanted to extend my Frame´s Arms and came to the Idea to Put some 16mm Tubes on it.
That means 13" Props for 250mm long Tubes ;)
This is the Result i wanted to share with the Community ;)
The Connector comes in 3 different Heights.
50-45mm M3 Screws for the 37mm Height (original height)
40-45mm M3 Screws for the 32mm Height
35mm M3 Screws for the 24mm Height
and 2 short ones for the back screws
The Rail holder is for 10mm Carbon Tubes with 60mm from axis to axis.
The 2 Holes to the side fit in the long slots on the bottom Plate
You can use this also to mount a 50$ 2 Axis Gimbal to the rail (center Hole used)
The Lipo Holder is needed if you want to put your Lipo as a counter Balance to the back (Gimbal in Front)
The Antennaholder is for the FrSky X8r antenna mount
The Clamps are for different wide Carbon Motor mounts. Just print 4 each
The Landing Gear i used is this:
Added a 37mm thick version to replace the Arms with original height Connectors. So you can use it on your TBS Discovery ;)
Also added a slotted version of the 37 and 32mm Version to put some wires out (LED´s perhaps anyone?? G
Print 4 Connectors, put some screws through the holes, fly ;)
I would recommend to Print it in ABS or like me with Colorfabb XT...