A Tablet stand with a bit of a difference. This stand will hold your tablet at one of two fixed angles 70 degrees or 45 degrees. Was designed specifically for a Nexus 10 however fits a Nexus 7 and should work with any tablet that is less that 11mm Thick.
I was having a look at all the tablet stands available and they just didn't have much style. All the other designs are very functional and use very little plastic, however I wanted something with more looks.
I originally designed it for a friend's Nexus 10, however my Nexus 7 fits in it perfectly and I imagine that it would work for any other tablet or iPad which is less than 11mm. There are two angles on the stand which allows your tablet to be held at either 70 degrees (20 degrees off vertical) or 45 degrees.
I printed this at 0.25mm layer height with 20% infill, with a double perimeter. It took about 4 hours and 20 minutes to print. If you are feeling adventurous then have a go at printing the mk3 STL which is a variation on the base design. It uses 70% of the plastic and takes 80% of the time to print. In my opinion it also looks cooler. I have yet to print it though. I will post a photo when I have done!