This is a little cam holder I designed for my QAV 210 quadro copter. Somebody from a forum I am active in asked me to share it. So here I do.
This cam mount is meant to be simply shoved over the front standoffs and held in place by mounting the top plate of the frame. The Camera is fixed with the threaded ring that comes with the PZ0420m camera. Other cameras with the same thread measurements should fit this holder aswell.
Note that you'll need to adjust the focus of you cam after inserting it in this mount since the cladding will require the lense to be screwed further in.
It should support 2,1 mm lenses quite snugly. If printed with PLA and my settings it weighs about 2.6g
Currently I have Variants in 35°, 40° and 45°
This has no real requirements. printing with any thickness should work quite nicely. Supports are recommended though.