This a dice tower that you can disassemble to store into the game box.
The design is based on the printer settings too. You must print with my settings to get the hex grid that encourages the dive movement.
If you want to get the hex grid you must slice it on slic3r with this settings:
layer height: 0.2mm
bottom: 1 (or 2)
Fill density: 0.3
Fill pattern: honeycomb
Fill angle: 45º
If you slice it on Cura you'll get an square grid:
Bottom/Top thickness (mm): 0.2 (or 0.4)
Fill density (%): 30 ...Infill:
Disable "Solid infill top"
Enable "Solid infill bottom"
Infill overlap (%) 15