The Bow Tie prints really well.
There are no supports that are needed.
No Glue or attaching of pieces is needed.
I gave this to a couple of my friends and their responses were very positive.
It clips on really easily to a 12 mm (3/8 in) wide button
Easy modification in a simple cad software can make the Bow Tie compatible with a different button size, but it should fit most.
Thank You for checking out my project.
I did incorporated an aspect of another designs, but I wouldn't consider my design a remix because the idea of a one-piece Bow Tie is original to my design.
Bow Tie ears are from "Exonoice"
Thank you for checking out my design.
Leave any comments down below.
The bottom of the Bow Tie prints very mesilly, but since that part is not visible it should appear fine.
To make the curves on the Bow Tie more accurate you can decrease the resolution.
The high resolution gives the Bow Tie nice texture.