Loading
willie

Rubber Duck

by willie Aug 25, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Nice design!!!

Any idea for trying to get floating? Maybe adding an infill base 100% and the rest to 0%? How can I do it this in Cura? Or I need to write in the gcode directly?

Hi did you get this floating.if so how did you do it.

Comments deleted.

Nice design! She doesn't float too well, however, strong tendency to roll :). Needs more weight in bottom...

You could decrease the % of infill higher up

In cura I can only have 100 % innfil or nothing shows up. I usually use 20, but if I choose that it dosent`t show any nnfill in the layer layout.

Absolutely brilliantly done.
Thanks, i've been testing filament with these at 30% size,
Just a little support under de beak is needed.

Thanks for the feedback!

Is it printable without support?

I printed this with both semi-flex and Ninja-flex very small without support successfully. Your results may vary..

Probably not.