Are you also doing your dishes by hand? Well I do and i got really tired of drying my cutlery by hand and i had nowhere to place them...
So I designed this elephant, inspired by Peleg Design.
It uses a channel and angle on the inside to let water flow outwards from the snout of the elephant. Prints best with solvable materials (PVA + PLA for example). The inside is OK without support, but the legs are right now a mess to remove PLA if you use only 1 extruder. I will update this shortly!
You can use a single extruder and get good result!
I printed with Orbi-tech PVA as support material, solved in cold water overnight.
Clear coat = waterproof
Using 2-3 layers of clearcoating (quite excessively on the inside) the model is fully waterproof and all the water left on the cutlery, channeling it out from the snout.
See how everything was made!