Owners of the larger pieces:
Thanks to ZhilDV, for the wonderful case for the Full Graphic Smart Controller Box.
Thanks to Leed3, with my help, he modified his "Robo3d R1+ Feet" to make a "High Lift" version that worked with the XXL controller (It since died on me) that I had.
So using those feet as a wonderful base.
Being that I hate super glue. I decided to meld/weld the legs of this controller box to Leed3's High Lift front right foot.
What I got was what you see in the pictures.
I printed at 18% infill
YES, it needs supports, "wiliro" reported that he used just used the "Touching buildplate" in Cura where I used "Everywhere". I think I would use the build plate after seeing the two prints.
Jam the nuts in BEFORE you assemble to avoid controller impacts.
Put the controller on the print before you connect to printer
Yes there is space left for the ribbon cable to be completely hidden below the controller
As always, comments good and bad welcomed :)
I was asked about my bed, it's my 330mm Upgrade located here.