Was wanting to find a dock for my Samsung Fast Wireless charger but all of the ones here were for the original Samsung wireless charger which is about the same diameter but much thinner. The other big difference is that for heat dissipation the new charger has a very small fan in the back and therefore requires ventilation. hbaulig's design seemed to be pretty open for ventilation so I extruded it's depth a bit. I had to make some tweaks to change the holder to be convex rather than concave like the original puck and added more ventilation holes in the back. It's a rather snug fit for the puck but it holds well and the cable management is top 'notch'. Note that the puck is intended to be installed Upside Down so that the Samsung microUSB cable can be plugged in through the tunnel inside the dock.
Update 1: I was having ventilation problems with the first version (puck would start flashing and stop charging occasionally), so I uploaded an update that has larger vent holes and is slightly larger to more easily fit the puck.
Update 2: Based on feedback, I updated the dock with a deeper phone tray to accommodate cases and leveled the feet so that they properly contact the floor and removes unnecessary support material on the feet issues some folks have. Download Samsung Wireless Fast Charger Dock v3.stl for the update. Note that the file is quite a bit bigger than the previous versions due to smoothing I did with MeshMixer. I'll have to see if I can find an app to simplify the mesh to reduce size.
Monoprice Maker Select 3d (Wanhao I3)
I did 15% and it was pretty solid