This is a male connector for the Sega Saturn Communication Port. I design this in the hope that it would make development of accessories of the port more accessible and affordable.
I've design it to be used with Molex KK 2759 spring crimp type pins since they are spring type connectors needed to give a good connection. You can buy these type of connectors on Digikey, Mouser, Aliexpress, etc.
Inside my 123D Design file I also have models for a connector that uses DuPont male pin connector but I have not tested it. If anyone has a better connector that can be used don't be shy to let me know (^_^). I prefer crimp type connectors since they don't require soldering to attach wires and possibly damage the connector plastic.
This is still a work in progress but I feel that it's a good enough state to be usable.
0.1mm layer height and 0.19mm nozzle width
I printed this connector using ABS on my DaVinci 2.0 Duo. Even though the printer has a 0.4mm nozzle I was able to get a good results by setting the nozzle width to 0.19mm in Simplify3D. I'm assuming that if the connector was printed with a 0.2mm nozzle the results would be better. If you have Simplify3D I've included the profile I used so you may take a look at the settings.
As always all the designs I make, this connector needs little to no post processing. You may use some ABS sludge or glue to make the pins hold better.