Simply wasn't room for the original fan-Mount when mounting ramps on the inside of the case and using my z-stage as well.
I lowered the entire part by 5mm and also resized the "side-wing" as they would otherwise touch the mosfets.
What you get
Using this you get around 12cm Z-heigh using an E3D hotend. More height with J-head or similar.
Make it 40% or maybe 100% infill to make them last. You do not want them to unclip due to low infill.
I printed using ABS, but you can print using PLA or whatever you like.
Do not use screws that goes too far Down and touches the mosfets or other parts of ramps/drivers.