Universal Phone Stand

by BCN3D Apr 4, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Thx! Printed fine without supports on my Creality Ender 3.

Am i allowed to sell some prints of the model in my school?

Can you publish the design files? -- I'd like to modify this.

I have printed 4 of these now and they do great until 90% completion, towards the top half of the overhang, where it begins to warp severely. Fairly new to 3D printing and I am using PLA in the Qidi x-one 2 printer with the Cura slicer. (10-20% infil, .2-.15 resolution, no supports, cooling enabled, 70mm/s print speed.)

Any advice would be greatly appreciated!


Turn down your print speed. Try 40mm/s. The overhang on these is not that bad and pretty easy to print. My very non-rigid repstrap with no heated bed can print them just fine.

It is so far the most beautiful, simple, and cost effective phone stand I found on the website. Thanks.
Though, it seems there will be a overhang problem. I am not sure. I will try.

This is a needlessly awkward shape for 3d printers. It should be rotated 90 degrees and the back taper removed, so that each layer stacks on top of the one below. As it stands, this file does not print well on older or less reliable printers.

The overhang is not that bad. -- My repstrap that is very non-rigid and fabricobbled together with bent lead screws has no trouble printing it.

it broke the first time i tried it

Did you read the instructions.

I didn't see any specific instructions on the summary page, just something about tagging it... Is there another file you meant to upload? Or is it in one of the youtube videos?