Thingiverse will be undergoing scheduled maintenance and will be unavailable from December 14 @11pm EST to December 15 @1am EST

Loading
helno

Stratux dual Nano RY835ai case

by helno Apr 13, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Just got this in, my 30x30x10 wont fit. I had to trim it to get the case to fully seat and still is flexing the fan and hitting the blades. Just ordered a 25x25x7mm and hopes that will work. The case is REALLY tight versus the notch. The anetnna cables are ziptied all over the place the be able to bend enough to close.

What screws is everyone using with this?

I mount the fans blowing out to avoid having the blades hit the case. Which fan are you using any 30x30x10mm should fit? Perhaps it ended up a bit tight due to shrinkage on the printer.

These older cases are designed to use M3 cap head screws. Regarding the notch case this one has nearly identical dimensions so any difference would be up to the printer.

I found a generic fan advertised for the Raspberry Pi on eBay. Thanks for the M3 suggestion, do you get them online or should Lowes have them in stock?

As for the notch case, it was semi-useful in having the antenna cables ziptied up in the notch area. Now that the SMA bulkheads go straight into the case, I had to move both of my SDRs into the middle and the semi-rigid antenna cables do not like the angles. But I'm not complaining, I got them bent in there where they can fit.

Thanks for the work, helno. I guess since this is your last design for the RY835ai, I'll have to pass this one along and move up to a Pi3 + VK.

I'll probably design a more updated one since people are working on AGRS again.

This is a great case, I installed a Raspberry Pi3 and had really no issues. With the RP3 they moved the LEDs over to the other side and the SD Card slot is designed differently I would recommend maybe adjusting the case design slightly to accommodate for those two issues. But these issues are definitely not show stoppers.

If you could take a few pictures I can make some changes.

Any update on this? I'd like to use the RasPi 3 with this case. Thanks!

It has openings on both sides no so the LEDS will be visible no matter what version of Rpi you use.

Great, thanks!!