The SVG had some artifacts when loaded into inkscape. There were diagonal lines in oddd places that had to be removed. Some of the ports still have duplicate cuts, which cause quite a bit of burning.
Additionally, my epilog driver uses #FF0000 for vector cuts, so I replaced the edges in the SVG with red thin lines.
The numbers are not cut out. This needs to be fixed.
epilog --dpi 300 -p 192.168.1.4 --raster-power 100 --raster-speed 12 --vector-power 100 --vector-speed 5 ~/output.pdf
Although the repeated cuts in the ports causes quite a bit of burning. Perhaps the vector cut order needs to be redone or, as suggested by Ben Jackson, the overlapping vectors need to be pruned.