I did not manage to find case for Orange PI camera, so spend this weekend trying to make one that should be able to mount on 10mm rod on Prusa I3.
This is my first design, so be gentle. Some parts are my creation, some are inspired by raspberry pi camera enclosures listed on Thingiverse.
This design is made of few parts:
-camera enclousure top
-camera enclosure bottom
-camera enclosure mount ( Its up to you to decide if you want it on the front or back side )
-arm connecting 10mm rod mount and camera enclosure mount
-10mm rod mount
In order to assemble it, use M3 screws, I think 16mm or longer will do fine.
NOTE: If printed with ABS (as I did) try to scale top and bottom part to 102.5% in case camera board does not fit when printed at 100%.
Fell free to remix and improve this design. This was created in 123D Design, so currently on STL and STEP/STP files are provided. If that is not enough, comment and I will see what can be done in order to provide other formats.
I used two top and bottom solid layers, 2 perimeters, outside-in perimeters. I did not break any parts but carefully remove them from heated bed ;)