Loading
eehrhard

Titan Carriage - Robo 3D R1/R1+

by eehrhard May 9, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

I cannot figure out how to install the ptfe tube coming out of the heat break. I cannot fit the cap on and slide it in. That thin plastic arch on the left center is in the way. How does your assemble this?

Am i missing something because i can seem to find the rest of the parts needed for the actual extruder

Is it possible to make this carriage so that it can accept the bronze sleeve bearings instead of the LM8UU ball bearings?

I use viacad, its about 40.00 on Amazon. it is extremely simple and lots of YouTube vids to teach you how to use the software. I made mine 15.45mm with a 10.4mm hole 24mm long and they work great

The chain you can get from Amazon that I linked has both ends. I have been meaning to model an attachment link for my chain but I have been super busy over the past month and have not found the time to get it made. I used the purchased injection molded link for mine though.

Do you by chance have a photo of the connection point to the other end of the cable chain? Just curious how you connected it.