I printed this to replace a missing door lamp in my wife's 2005 Honda Pilot. It's printed in clear PLA with concentric infill. No support is necessary. Snaps in place. Fits nicely. I haven't subjected the PLA print to Summer heat yet. If it doesn't work out, I'll print again in ABS.
Quick update: June 9th in Phoenix, AZ. Temperatures were 100+ last week. No PLA part warping yet. So far, so good. :-)
OK... Here's my last note: Sept. 9th, minimal warping. Part still looks good. I'm not gonna reprint. :-)