This FPV kit is designed for Turnigy 9X radio-controller with 7 "LCD screen and Boscam RC832 receiver.
I wanted to make a clean and practical kit, which can be fitted all the necessary equipment for FPV.
This kit mounts on the foot of antenna and a handle of the radio controller.Display bracket is designed in such a way, that it can be easily and quickly remove. Also, the screen angle adjustment is quick to make, thanks for GoPro-style attachment.
In addition, when the screen has been removed, GoPro mounting accessories fit directly onto the monitor bracket. So the video recording of the radio control succeeds very easily.
Behind of screen, I placed boxes for Boscam RC832 and for cables. Behind the boxes is 0.5mm hollow for the double-sided tape. The bottom of the cablebox has holes for XT60 connector and for ON/OFF switch. In order that XT60 connector stays in place, so glue it in place with a strong epoxy.
DEPENDING ON YOUR SCREEN, I made two different models of the boxes. The differences among these models are on the rear wall of the box, a another model wall is CURVER and the other one is STRAIGHT.
Battery mounting plate is mounted with a few drops of superglue
Note: You may need to use some sandpaper for the corner of the box, if it hits the back of the screen bevel. Again, this depends of your screen type.
Note2: You may need to cut and shorten the cables, so they can fit in cablebox.
Video RX: http://www.ebay.com/itm/121911788414?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
For this kit you will need these parts:
6x M3 nut
1x M5 nut
1x Gopro Thumb Screw or M5x20mm
All parts are printed on PLA with 0.2mm layer thickness.
Note: Some parts requires support material.