Shots taken by Jean Dzhermakyan
Nightfox Onyx Figurine as seen in Ocean's Twelve
Have you been planning to go head to head with Danny and Rusty?
Don't forget to leave this figurine.
Even if you aren't an Ocean's fan, this is a beautiful model to print!
I invaded one of my friends house who is a big Ocean's fan. Before he got home, I completely removed his huge TV off his drawer and left his wires hanging out, then placed the model as seen in the image above. What unfolded was an amazing reaction to a surreal event.
This can be a great and lighthearted prank for your friends, just make sure to give back what you take ;)
I printed in PLA
Rafts are recommended as the first couple layers are a bit hard to stick.
Make sure your supports are set to not stick to the print too tight.
I printed in PLA, then sanded and did a couple coats of glossy black spray paint for a nice Onyx look. While sanding, I focused more on where the supports were attached.
I also used white nail polish for the two small eyes! (only seen in the second image above).