1:8 scale action figure of the BattleBots robot Overhaul, shown in its Season 2 form! Movable, posable joints!
Note: This model may not be reproduced for commercial purposes.
Print & Assembly Instructions
All pieces can be printed laid flat with no supports.
Use #4 x 3/8" or shorter wood screws to attach the pontoons to the body. For other connections, use 1/16" diameter pins, welding rod, or rigid wire cut to appropriate length.
Use a 1/16" drill bit to clean up the wheel axle holes, arm tower and arm pin holes. if needed. The top plate may require minor edge trimming. It should snap cleanly downwards from the top into the body.
Use CA glue to bond the top arm components (top arm innards, top arm left and right) together.
Two spacer types are provided to account for printer variations. If the joint doesn't have enough friction to stay in position, you should use the longer spacer.