Special thanks to ch00ftech. For more info check out his blog post http://ch00ftech.com/2011/12/31/stronger-glasses/
- Print the frame and the arms
- Build an audio leveling circuit. you can use ch00ftech's circuit. or a simpler option is to use the LM3914 Bar Display IC. You will need optocouplers/triac drivers to control the EL power supply
- Solder EL wire to the glasses.. use hot glue to keep in place and make sure to cover all conductors. EL uses 100+ volts, unless you want to electrocute your face, take care to make sure this is done well.
- Glue arms to frame and run wires along the arms.
If you use gray PLA, its the same color as duct tape, so you fasten the wires with duct tape! score!