Hey there, fellow 3D-printing enthusiasts!
This is my take on a SD card holder/ desktop organizer.
It offers space for up to 4 SD cards, 4 USB devices, 2 micro-SD cards and 2 pencils with a
diameter up to 10mm.
Feel free to post your design wishes or suggestions in the comments.
If you successfully made one, please share your results!
Be careful when removing it from the printbed!
The connection between cube and gearwheel might break if you pull on the cube.
Works best if you use some kind of spatula.
I recently added a self-adhesive anti-slip mat to the bottom of my own desk-cube, because it slid around quite easily. Especially on smooth surfaces like glass.
Cutting these mats can be a little tricky, so i added a cutting template (PDF) of the
projected gearwheel that allows you to transfer the design 1:1.