Rocket Launch Controller 9V
Controller for launching model rockets, It works with a 9v battery (the most widely used voltage for model rockets). Essential and lightweight design. Banana sockets, for different lengths of cable. The aeronautical switch gives a professional look and protects against unexpected launches. The electronic circuit is entry level and affordable for all.
Thanks to this project, you can create a launch controller for Model Rocket. Easy to use and safe.
Components (Step 1)
The components used in this project are:
- Aeronautical Switch (x1)
- Round Switch Normally Open (x1)
- Red Led (x1)
- Green Led (x1)
- 4.7K Ohm Resistors (x2)
- Female Banana Plugs (x2)
- Battery connector (x1)
The tools for this project are:
- Tin wire
- Screwdriver multi tool
- 9v Battery
Assembly (Step 2)
1) Print above and below the controller
2) Weld and connect the components as shown in diagram
3) Enter the electronic circuit within the controller
4) Attach the 9v battery in the connector
5) Close the lid by inserting
Before using your circuit:
Place a voltmeter in the two banana plugs, turn on the switch end press the round button. If the voltmeter marks the voltage of the battery, the circuit works!!
After testing the circuit:
Insert the cables into the banana plugs, turn on the switch ( The green light of the led, It is to mean that the circuit is turned on). When you're ready to launch your Rocket Model, press the round button (The red light means that the signal has been sent to your rocket).